I have just figured, if I can print DIAGONALLY, my printer can print sides up to 11 inches long. The base and top will require another approach however.
@techristian , The board is smaller than an Amiga 1000. Very little chance you could fit it in and be able to access all the input/output connectors easily.
All those Commodore boards were huge. The Foenix board is around 10" x 7" in its actual form. Considering the enclosure it is going to be fitted in, it might get smaller or bigger. Difficult to say at this point.
I have just figured, if I can print DIAGONALLY, my printer can print sides up to 11 inches long. The base and top will require another approach however.
Dan
Smaller is better because most inexpensive 3d printers can do 8x8x8 unless I can figure a way to it in 2 pieces.
@techristian , The board is smaller than an Amiga 1000. Very little chance you could fit it in and be able to access all the input/output connectors easily.
All those Commodore boards were huge. The Foenix board is around 10" x 7" in its actual form. Considering the enclosure it is going to be fitted in, it might get smaller or bigger. Difficult to say at this point.
S